When installing a SCSI tape drive, you must use a SCSI host adapter that is supported by SCO OpenServer. Refer to the SCO Certified and Compatible Hardware web page (CHWP) for a listing of supported host adapters and drives. You should also verify with your hardware supplier that the drive will work with the host adapter. See UNRESOLVED XREF-0 for information about supported mass storage drivers.
The tape(C) utility allows you to perform various tape control functions (such as rewind, erase, format, retension, and so on) if they are supported by the device. Access to tape drives is via character (raw) special device files only; there is no block device access. A no-rewind device exists for writing multiple tape archives to a single QIC-02 or SCSI tape.
You can also use tape compression, partitioning,
and variable block size with SCSI tape
drives that support these features.
The tape(HW) manual page describes generic support for tape drives. The manual pages listed below contain specific information about each type of tape drive:
See also ``Troubleshooting tape drives''.