Installing a hard disk

For all disk controller types, it is assumed that you have already physically installed the hard disk and booted the system.

This section describes how to install an additional IDE, EIDE, UDMA, ESDI, IDA, SCSI, or USB hard disk. If the disk is SCSI or USB, you must already have updated the system configuration files, as described in ``Configuring a SCSI hard disk'' and ``Configuring a USB hard disk''.

1. Log in as root and put the system into maintenance mode.

2. Select Hard Disk from the devices listed by the Hardware/Kernel Manager, or enter the command mkdev hd. (Enter mkdev hd -u or mkdev hd -h if you require detailed usage and help information for mkdev.)

3. Select the type of hard disk that you want to add to the system.

4. IDA disks: Enter the logical number of the disk and the number of the controller to which it is connected.

   SCSI disks: Enter the host adapter type and number, the bus number, the disk controller ID, and the LUN of the disk.

   USB disks: Enter the USB device ID and the LUN of the disk.

   ST506, IDE, EIDE, UDMA, or ESDI-interface disks: Enter the number of the disk on the controller. If you are installing IDE, EIDE, or UDMA disks on ISA or EISA bus machines, you must also enter the number of the controller to which the disk is attached.

5. Choose to continue the installation, or exit. If you choose to continue the installation, the driver outputs a message to show it has been initialized.

   The mkdev hd script now runs the programs dkinit(ADM), fdisk(ADM), and divvy(ADM) in sequence to configure the hard disk for use.

   • If your disk has an IDE, EIDE, UDMA, ESDI, or IDA controller, mkdev hd runs dkinit(ADM) to allow you to change the physical parameters defined for the disk such as its geometry, and whether it supports error correction. See ``Changing default disk parameters using dkinit'' for more information.

     dkinit is not run for SCSI disks. If you move a SCSI disk between machines or change the host adapter, you may need to run dparam(ADM) on the disk to change the geometry defined in the masterboot block. See ``Writing a new masterboot block'' for more information.

   • The mkdev hd script runs fdisk(ADM) to allow you to create disk partitions. See ``Partitioning a hard disk using fdisk'' for more information.

   • The mkdev hd script runs divvy(ADM) to allow you to divide a UNIX system partition into separate filesystems and swap areas. See ``Dividing a disk partition into divisions using divvy'' for more information.