DOC HOME SITE MAP MAN PAGES GNU INFO SEARCH PRINT BOOK
 
Hardware configuration overview

ATAPI/EIDE peripheral bootstrings

The bootstring to specify the location of an ATAPI device (such as a CD-ROM, tape, or LS-120 drive) on the EIDE (IDE) bus is:

periph=wd(number, 0, ID, 0)

The parameters in this bootstring are:


periph
Internal name of the peripheral interface driver. Possible values are:

Sflp
floppy disk drive (including LS-120/240 drives)

Srom
CD-ROM drive

Stp
tape drive

number
The ATAPI/EIDE device, where 0 specifies that the device is attached to the primary controller and 1 specifies it is attached to the secondary controller.

ID
The controller ID, where 0 indicates that the device is master and 1 indicates it is slave.
For example, to specify a CD-ROM that is on the secondary IDE controller that is set to master, enter:

Srom=wd(1,0,0,0)

If the CD-ROM is the only device on the IDE interface, it must be set to master.


NOTE: Please note that you cannot specify IDE hard drives in the same manner. If IDE hard drives are present, the installation uses the Primary/Master IDE hard drive as the root drive.


Next topic: EIDE/UDMA host adapter bootstrings
Previous topic: SCSI host adapter bootstrings

© 2005 The SCO Group, Inc. All rights reserved.
SCO OpenServer Release 6.0.0 -- 03 June 2005